Duplo DB-200 User Manual download pdf (Page 6)

Installation

Note: You must remove the three red shipping brackets before installing your DB-200.

The procedures for installation:

Remove the red shipping bracket located on the

left side of the clamp station as shown. Then

reinstall the screws in clamp station.

2. Remove two red shipping brackets that are

located around the nipping station as shown.

Lift up your DB-200, then slide in the bottom

cover ( glue draining tray ) underneath the glue

tank as shown.

Place your DB-200 on a safe, firm and solid

table. Then mount the cover-sheet holder to the

right side of the machine as shown.

Note: (A) For Adjusting the Glue, Replenishing the Glue Tank, Nipping Pressure

Control or Glue Replacement, please refer to the operation procedure (F),

(G) and (H) for details.

(B) You also can change the factory settings of your DB-200 operation if

necessary. Note that we only recommend you to change TR1. For “SETUP FOR

TIMERS”, please refer to APPENDIX on page 14.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

No comments

Duplo DB-200 User Manual Page 6