Duplo DB-200 User Manual download pdf (Page 18)

The fastest speed of settings that AUTO mode can perform is:

TR1 = 2 sec., TR2 = 0.5 sec., TR3 = 1 sec., TR4 = 0.5 sec., TR5 = 0.5 sec.

• Note that the book making speed depends on thickness of the book and the loading

technique for the paper and cover.

ERROR DISPLAY:

LED Display Description Cause of Error

ERR = L1 Clamp station is 1. MT1 - fuse blown.

not in the home position. 2. LS1 - sensor is bad.

3. MT1 - motor problem.

ERR = L2 Clamp station is 1. MT1 - fuse blown.

not in the left holding 2. LS2 - sensor bad.

position. 3. MT1 - motor problem.

ERR = L3 Nipping station is unable 1. MT2 - fuse blown.

to reach the lowest 2. LS3 - sensor bad.

position. 3. MT2 - motor problem.

ERR = L4 Nipping station is unable 1. MT2 - fuse blown.

to reach the highest 2. LS4 - sensor bad.

position. 3. MT2 - motor problem.

ERR = T1 After warm up more than 1. Heater fuse blown.

one hour, binder is not 2. Temperature switch bad.

ready to bind. 3. Heater bad.

TEMP ERROR Temperature too low. 1. Heater fuse blown.

2. Temperature switch bad.

3. Heater bad.

HALF00 Skip from Cold to Hot. 1. Stand by sensor bad.

2. Thermostat bad.

Note: Check all electrical connectors of appropriate items when

troubleshooting errors.

1 2 ... 13 14 15 16 17 18

No comments

Duplo DB-200 User Manual Page 18