Duplo DB-280 Instruction Manual download pdf (Page 37)

~37~

4.4.4 Auto Mode

Note: All books done in this mode must be same thickness.

In the MANUAL mode, make one book.

Centering the cover to the centered point and adjust the side

guide.

Press “FUNCTION” button to switch to “AUTO” operation.

The “AUTO” LED will be lit and display flashing "LOAD

BOOK" as shown. Note: The “NOTCH” LED is ON.

Step 1:

Load book to the

RIGHT of the red line.

Step 2:

Slide the book to

The far LEFT.

(1) Press the “OPEN” button. Be sure to follow the label

instructions on the clamp to load the book block to the RIGHT

of the red line, then slide the book block to the far LEFT of the

clamps and you will see the flashing "PUSH CLOSE" display.

(2) Then press the “CLOSE” button to clamp down the book

block and you will see the flashing "PUSH START" display.

Note:

In case you need to adjust the book block after you have closed

the clamps, you can press the "OPEN" button twice to release it.

The LED display will show "PUSH CLOSE". After you have

adjusted the book block, you have to press "CLOSE" button

until the clamps close. Then you will see the flashing "PUSH

START" display again.

(3) Press the “START” button. The LED DISPLAY of control

panel will show the “Å” sign. The clamp station will move to

the left side of DB-280 and will remain there.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 68 69

No comments

Duplo DB-280 Instruction Manual Page 37